The problems that must be paid attention to during the construction of Zhongshan epoxy floor paint

   Nowadays, people are increasingly seeking more and more things. The application of colored floor paints has become more and more extensive. As a new type of floor decoration material, it is favored by more and more projects, but there are many difficulties in its construction. Floor paint because of its clean and smooth, easy to clean, seamless, wear-resistant, impact-resistant, can not afford sand and other advantages, the introduction of positive and negative floor coatings in the construction of the floor must pay attention to the following issues ：

First, the grassroots must be dust-free and greasy. If dust needs to be vacuumed thoroughly with a vacuum cleaner. The grease adhered to the ground is wiped clean with solvent. If the ground is undulating, use a sander to polish the ledge and use a floor substrate or an epoxy putty to repair the pit.

Second, the moisture content of the grass-roots level is very important for the construction of Zhongshan epoxy floor paint. Before the floor construction, the moisture content of the grassroots must be measured with a moisture meter. If the ground is wet (water content ≥10%), it must be baked back and forth with a gas lamp, and the ground moisture is measured with a moisture meter. The ground water content is less than 10% before construction. .

Third, the leveling of the ground should be based on the roughness of the ground and the material requirements of the paint used to select the appropriate coating materials. For the thin coating, it should be selected Asher floor paint putty layer leveling the ground; for thick coating, should choose Astra floor paint reinforcement layer to achieve a certain thickness. In the use of reinforcement layer, according to the actual situation, can use different tooth pitch trowel, and can properly adjust the ratio of aggregate A and aggregate B, in order to achieve the desired thickness and strength. Aggregate A is weak but has a smooth, smooth surface; aggregate B has good strength but a rough surface.

Fourth, for the ES color floor paint construction can be rolled, painted, sprayed, coated and other methods of construction. If roller coating is used, the number of roll-rollings on the entire surface must be uniform to avoid chromatic aberration. Regardless of roller coating or trowel coating, if the construction interval of the joint is too long, be sure to use thinner to wipe the joint seam to avoid color difference between the rear coating and the front coating.