Zhongshan Epoxy Floor Paint Construction Standards and Maintenance

1, the ambient temperature of 25 °C, 2-3 days after the construction should be to achieve dry, that is, the hardness reaches about 80% of the completion of curing;

2, the surface can not appear sticky phenomenon;

3, bubbles: flat-coated, mortar-type bubble, self-leveling allows a small bubble / 10 square meters;

4, leveling is good, no knife marks, a large area of the interface is basically flat;

5, no floating color hair, uniform color, large area interface allows very obvious color difference;

6, no coarse impurities, but allow the floating dust in the air drop caused by the smallest defects;

7, the floor surface should be smooth, the gloss should meet the design requirements (high gloss ≥ 90, light ≥ 70, half light 50 ~ 70), flat-coated type is light, water is semi-light ~ no light;

8, orange peel, mortar anti-slip surface effect should be very obvious. No volatile organic emissions are widely used in the finishing of modern industrial floors.

performance:

Epoxy floor paint has strong acid-alkali resistance, abrasion resistance, pressure resistance, impact resistance, mold resistance, waterproof, dustproof, anti-slip, anti-static, electromagnetic wave and other characteristics, bright and diverse colors, easy to clean. Widely used in electronics factories, machinery factories, hardware factories, pharmaceutical factories, automobile plants, hospitals, aviation, aerospace bases, laboratories, offices, supermarkets, paper mills, chemical plants, plastic processing plants, textile mills, tobacco plants, Confectionery factories, wineries, beverage factories, meat processing plants, parking lots and other surface coatings.

Zhongshan Epoxy Floor Maintenance:

Zhongshan Epoxy Floor Paint is a high-value, high-quality, high-required product. The correct use of the method can ensure that the ground is always kept as new, and can be used for a long service life. The specific recommendations are as follows:

1. After the construction of the pedestal, it needs to be maintained for 7-10 days before it can be put into use. During the period of maintenance, water or other solution should not be allowed to infiltrate the surface.

2. All employees who enter the workshop must be replaced with rubber-soled shoes (not wearing black shoes with foam bottom) (so as not to scratch the ground when the outside mud is brought into the workshop)

3, all hardware: such as iron chairs, iron tables and iron shelves, their feet should be wrapped with soft plastic, rubber or paper pad to avoid scratching the ground during use

4, the tractor pulls must fully lift the board off the ground, please pay special attention to the corner of the board when turning, do not scratch the ground

5. When cleaning the floor, please use a soft mop with good water absorption or a wet or dry vacuum cleaner, which can be cleaned with water or detergent, but please note that the floor is slippery

6, if the use of a long time due to wear or scratch, small area can be repaired, if the area is larger, it is recommended to re-roll once

7. Before the equipment enters the factory, lay a hard carton bottom on the floor to avoid scratching the ground during the transportation of equipment.

8. Please use hard or elastic rubber wheels for the wheels of carts and carts, and use them separately inside and outside the factory building.

9, can be based on the requirements of the ground to do waxing (the effect of preventing scratches on the ground)